Dos Networking
|
Original Message
|
Name: brianbek
Date: November 26, 2004 at 16:18:13 Pacific
Subject: Dos NetworkingOS: MSDOS6.22CPU/Ram: 486DX266 / 3MEG |
Comment: Need some networking help, This computer is actually located within a CNC milling machine, it has networking capabilities, and does see a ip network fine(msclient3), the problem is I need more conventional ram for the control program to load, memmaker run,loaded everything high or UMB, got about 495-500k free, but need more. Any suggestions would be help. Thanks.
Report Offensive Message For Removal
|
|
Response Number 1
|
Name: Mechanix2Go
Date: November 26, 2004 at 22:04:38 Pacific
Subject: Dos Networking |
Reply: (edit)Aside from the creative tinkering we used to do, my experiece was that QEMM was better than M$, BluMax etc. M2
 Report Offensive Follow Up For Removal
|
|
Response Number 2
|
Name: rogerashley
Date: November 27, 2004 at 02:16:42 Pacific
Subject: Dos Networking |
Reply: (edit)Do you need the full capibility of MS Network Client 3.0 ?? If not you can just use simple WATTCP and NIC's, a Packet Driver is required for the NIC: http://www.smashco.com/wattcp.asp http://www.mwpms.uklinux.net/index.htm
Report Offensive Follow Up For Removal
|
Use following form to reply to current message:
