Compaq PCMCIA
|
Original Message
|
Name: Jerry
Date: February 15, 2001 at 13:37:14 Pacific
Subject: Compaq PCMCIA |
Comment: I am working on a Compaq Armada 7792DMT with a 3com; 3C574TX PCMCIA network card. I need to boot this computer up from dos. I checked Compaq's sight and did not fined any dos drivers for the PCMCIA slots. Also, I did not fined any help on 3Com's sight. When I try to boot from a dos disk it will lockup when the card driver tries to load. The system drive (C:) has Windows 98 and the PCMCIA network card works fine. Any help would be appreciated!!!
Report Offensive Message For Removal
|
|
Response Number 1
|
Name: Preston
Date: February 15, 2001 at 20:41:04 Pacific
Subject: Compaq PCMCIA |
Reply: (edit)go to: http://www.powerload.fsnet.co.uk/ and click open the PCMCIA card software page. You'll see a nice selection of card services software. One is sure to work for you. Just remember, you cannot (normally) load card software in DOS mode and then run Windows 9x. They will conflict. If you use config.sys drivers, do not plan on running Windows.
 Report Offensive Follow Up For Removal
|
|
Response Number 2
|
Name:
Date: February 16, 2001 at 14:06:26 Pacific
Subject: Compaq PCMCIA
|
Reply: (edit)If you goto www.compaq.com and follow driver links, you WILL find Compaq PCMCIA Drivers. I have seen them.
Report Offensive Follow Up For Removal
|
|
Response Number 3
|
Name: Jerry
Date: February 27, 2001 at 13:37:26 Pacific
Subject: Compaq PCMCIA |
Reply: (edit)Thank you for the help Preston. I needed to image a laptop so I could rebuild 9 others with the same data. The software I use "Lab Expert" is dos driven.
Report Offensive Follow Up For Removal
|
Use following form to reply to current message:
