after finally solving my cpu temp. i decided to try some oc, i have a msikt4v, ati 9500 pro, amd 2800+, 1.0 2700 ddr, my problem is that i adjusted my fsb to about 185, left cpu ratio in auto and when i got to the windows screen the video was green, i lowered the fsb back to 166, started it again and the video was fine. does the changing of fsb also affect the video sinc as well?

the AGP bus speed increases as the FSB speed is increased as it is usually set as a ratio of the FSB.On my VIA based MOBO the AGP speed is 1/2 the FSB I am at present running with an FSB of 150 and Sandra shows my AGP as 75 and this works well with my Radeon8500..but anything over this and my video card fails to function properly.

is my video card dead, i just tried running 3d mark 2001, and the low detail is running at 34 fps, when it use to be at 220 fps, i just reinstalled my drivers, reformated and all, and still the same results,, when i try and run dxdiag when it goes to test the 3d part it crashes to a diagnostic screen and freezes. could i have burned it while oc my cpu, are there any other test i can do to dtermine if it is gone, i can still use my computer for internet and all, just not the high end part, oh by the way its a ati radeon 9500 pro or was.