Upgrade CPU
|
Original Message
|
Name: gtr161
Date: January 28, 2005 at 18:46:34 Pacific
Subject: Upgrade CPUOS: Win 2000 ProCPU/Ram: Sempron 2800+/1 gig |
Comment: Ive recently upgraded my CPU from an old AMD Duron 700 (I think) to the Sempron 2800+ chip. On boot up, I get a message to reset my CMOS settings. Can anyone help me with these settings? Do I need to flash my BIOS?
Report Offensive Message For Removal
|
|
Response Number 1
|
Name: MunkyPoo4u
Date: January 28, 2005 at 18:55:23 Pacific
Subject: Upgrade CPU |
Reply: (edit)cmos is a jumper on your motherboard its usualy located right above the power and reset wires its 3 lil pins with a jumper covering only two of the pins just turn your pc off make sure that the powercord is disconnected remove the jumper from the two covered pins and place move it up one pin it'll still cover two pins leave it there for like 3 or 5 seconds then place the jumper back on its orginal pins and start your pc back up again it'll go into your bios settings set your cpu speed and all that junk and bam your set or should be set
 Report Offensive Follow Up For Removal
|
|
Response Number 2
|
Name: jam
Date: January 29, 2005 at 06:15:44 Pacific
Subject: Upgrade CPU |
Reply: (edit)If you have an older BIOS, yes, it will have to be flashed to support the Sempron. I assume your board is the EPOX 8RGA+?
http://www.epox.nl/english/support/bios.php
http://www.epox.nl/english/support/bios/socket.php?id=8
Report Offensive Follow Up For Removal
|
Use following form to reply to current message:
