would anyone have any settings for this set up?? I also have nothiced that si sandra registers my multiplyer as 1 less than what i have it set at, i was running at 1.65mgz stable but looking to go higher.... any help would b appreciated, thanx

dont reall understand ur question...

he's asking for the default FSB and multiplier values...i think

Ihave my mulitply at 12.5 but it still registers it at 11.5 yet i did do the unlocking of it b/c it is a palimeno

sounds like a bug in Sandra. to see your real settings, then use wcpuid

Adolph unlocked his cpu by filling the cuts with epoxy, as recommeded on an OC website. We then bridged the points with Circuit Works silver grease. When he booted up the first time under default FSB, Mult it recognised as XP 1800 (133 x 11.5). But when we upped it to 150 x 12 both the system, and sis sandra said it was 1.65G (150 x 11). We also tried 145 x 12.5 and it recognized 145 x 11.5; ie it is subtracting one from the multiplier. I suspect that one pair of points did not get bridged properly due to epoxy on the point, as all grease lines are seperate. He hoped that someone might have had same prob with this board, and it was not the cpu. If not does anyone know how to remove the epoxy?