Security & Virus | Hardware | Windows XP | Windows Vista | PC Gaming

jumper settings

Comment:

i have an old 1998 compaq presario motherboard that i thought was shot, turns out, only the stick of memory i had was bad, since i thought the processor was bad i threw it out. i recently bought a new one off of ebay to replace it and i need to make sure the overclock jumper settings are correct. caleb williams

Name: SkipCox
Date: March 13, 2006 at 20:34:52 Pacific

Reply:

That thing came with a Cyrix MII-300 processor? What did you buy? We need enough information to answer your question. For example, the Cyrix runs at 75Mhz fsb and an Intel would be overclocked at that speed (66Mhz fsb would be the default for an Intel). If you were a real geek_, you'd tell us what we're workin' on. :) Skip

0

Althlon x2 of pentium D

2800 sempron + 7kt400a

Post Locked

This post is quite old and has been locked from receiving new replies. Please create a new posting instead.

Summary: just double checking before I power up the new comp, a 2.8c w/HT should have the 133 clock speed jumper setting, correct? ...

Summary: i need the jumper setting for a 5vgm m101 motherboard with a 233 intel 233/mmx.i found where it will support a 233 but all i coud douwnload is quick reference jumper setting chart that only gose to a ...

Summary: Can you boot-up with clear CMOS jumper setting(what will happen)? Bought new motherboard(KT4 ULTRA) fixed all other hardware and followed all instuctions as per manual. Jumper setting pin 2-3=clear CM...