|Here you go|
Full System Restore on Advent Vega
To restore your Advent Vega to our latest base image, please follow the steps below:
DOING THIS WILL REMOVE ALL YOUR APPLICATIONS – YOUR SD CARD STORAGE WILL NOT BE
Download the Advent Vega USB Flash driver from www.myadventvega.co.uk
Download the latest Advent Vega restore image from www.myadventvega.co.uk
Extract the USB flash drivers to a folder on your PC (eg C:\Advent\)
Connect the Advent Vega to your Windows PC with the supplied USB cable, you must also
have the Vega PLUGGED INTO THE POWER SOCKET
Place the Advent Vega into recovery mode by:
o Turn the Vega off by holding down the POWER button for 6 seconds
o Once off, hold the BACK button down for 2 seconds
o Then, whilst keeping the BACK button held, press and hold the POWER button for 2
o Then release just the POWER button but keep holding the BACK button for a further
o Release the BACK button
If this is the first time you have completed this you will need to install the Advent Vega
o Windows should automatically prompt you for a driver – if so point it to the folder
you extracted the driver to above – THIS DRIVER IS CURRENTLY NOT SIGNED – YOU
WILL NEED TO ALLOW THE DRIVER TO BE INSTALLED WHEN PROMPTED – DO NOT
BE ALARMED BY THIS MESSAGE
Once installed, double-click on the Advent Vega Restore Image file downloaded above.
A DOS window will appear – DO NOT REMOVE OR POWER OFF YOUR DEVICE SURING THIS
Once the image is installed, you will be prompted to press ENTER to exit. Your Advent Vega
should now be restored/updated.
Remove the USB cable.
Power on your Advent Vega – Your system will now be updated.